- Spare Tire and Wheel
- Red or Black Skin
- Tailwind
- Horse Combo
- Mid Tacks
- Side Mangers
|
Side Mangers w/ Access Doors
 |
Red Skin Genesis
 |
Black Skin Genesis
 |
Genesis w/ Tailwind
 |
|
Mid Tack Door w/
Graphic
 |
Stall Divider
 |
Spare Tire
 |
Slam Latch
 |
|
- Spare Tire
- Tailwind w/Plexiglass
- Red Skin
|
- Red or Black Skin
- Side Mangers w/access doors
- Mid Tack Door
|
Ramp Behind Double Rear
Door
|
Heavy Door Hinges
|
Inside of Dressing Room on Genesis
Straight Load
|
|
| 7' wide Genesis- Slide out Standard
Locations
Package #40- Slide out rough opening size- 67.25"
wide x 73.63" tall:
- 13" back from GN drop ONLY!!!
- Camper door- passenger side ONLY!! 54" back from
GN drop to front of camper door opening.
- THIS PACKAGE AVAILABLE ON 40" EXTENDED MODELS ONLY
Package #80- Slide out rough opening size- 80.5" wide
x 76.25" tall:
- 13" back from GN drop ONLY!!
- Camper door- passenger side ONLY!! 63" back from
GN drop to front of camper door opening
- THIS PACKAGE AVAILABLE ON 80"EXTENDED MODELS ONLY
Package #120- Slide out rough opening size- 80.5"
wide x 76.25" tall:
- 13" back from GN drop ONLY!
- Camper door- passenger side ONLY!! 77" back from
GN drop to front of camper door opening.
- THIS PACKAGE AVAILABLE ON 120" EXTENDED MODELS
ONLY
|
8.5' wide Genesis- Slide out Standard Locations
There is only one size of Slide out available on the
8.5' wide Genesis:
-
Rough opening size is: 80.5" wide
x 76.25" tall.
-
Placement is on Drivers side wall, 13"
back from GN drop to the front of rough opening.
-
Height measurement is from the top of
the aluminum frame rail (not from floor)
-
The passenger side wall is not affected
by the addition of a slide out to the opposite wall.
|
Slide Out Rules:
- Measurement for height is from top of existing frame
rail {not floor}
- No slide out AND camper door on the same sidewall
- No more than one slide out per unit.
- No device may be installed on the sidewall that slide
out is located on that severs or cuts into any structural
member intended to add strength to slide out opening
- Additional exterior sheeting shipped with unit
to finish outside of slide out box.(color match)
- These rough openings are intended to be used with the
"LIFTCO" brand slide out assemblies.
- Framing for refrigerator vent, hot water heater vent
and furnace vent are not included in these packages.
|
| See
Your Local Dealer for Other Options |